Creating safe and robust waterproofing solutions to structures

Creating safe and robust waterproofing solutions to structures

The basis of waterproofing structures is to stop water ingress, reduce risk and to prolong the lifetime of a structure. Developments within the construction industry have seen a change in how we view structural waterproofing. From residential to commercial, from small to large, all projects require the same approach.

The provision of waterproofing systems can be employed to upgrade existing basement rooms, waterproof new buildings or convert damp, unused below ground spaces into dry habitable rooms.

Delta Membrane Systems Limited’s Managing Director, Christopher Burbridge, explores the  complexities to waterproofing design solutions.

The introduction of BIM (Building Information Modelling) at key stages of a project draws on collaborative assembled information. BIM has created value in the design process.  The model-based approach increases efficiency within the build process and coordinated project delivery.

BIM drives time and budget savings for building and infrastructure alike. Technical Drawings are also vital in visually communicating how a waterproofing system functions or is constructed and are a valued tool.

There are three grades to waterproofing below ground structures,

  • Grade 1 – basic utility – car parking, plant rooms (excluding electrical equipment) and workshops
  • Grade 2 – better utility required from Grade 1 – workshops and plant rooms requiring drier environments
  • Grade 3 – habitable – ventilated residential and commercial areas

A, B and C Waterproofing Systems

There are also three types of structural waterproofing systems available within the United Kingdom:

Type A Barrier Protection

Type A (Barrier) Protection, often referred to as “Tanking”, provides protection against ground water ingress by application of a waterproof material to the negative (external) walls and structural slab of a basement or underground structure to form a barrier between the structure and any groundwater present.

Type A materials can be applied to either the negative (external) or positive (internal) surface of the wall/floor and also in between wall or floor surfaces. Type A systems can offer a double layer of protection when applied to both negative and positive surfaces.

Type A materials include: Liquid Applied Membranes, Bonded Sheet Membranes and Cementitious slurries and powders.

Type B Structurally Integral Protection

Type B (Structurally Integral) Protection is the incorporation of materials to the external shell of the structure itself. They include; Reinforced water-resistant concrete or reinforced water-resistant structural steel.

Emphasis to the importance of design, materials and quality of workmanship are placed when specifying a Type B system due to the pattern of any seepage, poor joints, cracks or other discontinuities such as service penetrations.

Type C Drained Protection
Type C materials include: Cavity Drain Membranes and Submersible Pump.

Type C (Drained) Protection is the incorporation of a cavity drainage system (internal water management system).  In principle a Drained Cavity System collects and manages any ground water which breaches the integrity of a structure by managing, collecting and discharging such free water via a suitable evacuation point such as a packaged pump station.

The Cavity Drainage System provides protection to a structure by application of a dimpled High Density Polyethylene (HDPE) membrane which is applied to the positive (internal) walls and structural slab of a basement or underground structure to form a barrier between the structure and any groundwater present.  A cavity drain system requires minimal preparation and disturbance to an existing substrate.

Combined Systems

Some building warranty providers insist on two forms of waterproofing on projects where they are to provide the building warranty. Difficult and complex projects may also require combination waterproofing.

British Standard 8102:2009 recommends the consideration for combined systems where the risk is deemed high.  A Waterproofing Design Specialists would have the knowledge and understanding of a range of waterproofing systems to provide a robust design based on compatible materials. As with all waterproofing protections, all rely heavily upon the design and how these materials are incorporated into a project.

 

LEAVE A REPLY

Please enter your comment!
Please enter your name here